Harbor Freight Tools High Chair 90849 User Manual

ADIRONDACK CHAIR  
90849  
ASSEMBLY AND OPERATING INSTRUCTIONS  
3491 Mission Oaks Blvd., Camarillo, CA 93011  
Copyright © 2003 by Harbor FreightTools®. All rights reserved.No portion of this manual or  
any artwork contained herein may be reproduced in any shape or form without the express  
written consent of Harbor FreightTools.  
For technical questions and replacement parts, please call 1-800-444-3353  
 
8. Use eye and ear protection. Always wear ANSI approved impact safety  
goggles during assembly.Wear a full face shield if you are producing wood  
chips.Wear an ANSI approved dust mask or respirator when working around  
wood, and chemical dusts and mists.  
9. Take caution as some woods contain preservatives such as copper  
chromium arsenate (CCA) which can be toxic. When cutting these  
materials extra care should be taken to avoid inhalation and minimize skin  
contact.  
10. Check for damaged parts. Before using this chair, any part that appears  
damaged should be carefully checked to determine that it will operate properly  
and perform its intended function. Any part that is damaged should be properly  
repaired or replaced.  
11. Replacement parts and accessories. When servicing, use only identical  
replacement parts. Use of any other parts will void the warranty. Only use  
accessories intended for use with this item. Approved accessories are  
available from Harbor FreightTools.  
12. Do not assemble this chair if under the influence of alcohol or drugs.  
Read warning labels on prescriptions to determine if your judgment or reflexes  
are impaired while taking drugs. If there is any doubt, do not proceed with  
assembly.  
13. Maintenance. For your safety, service and maintenance should be performed  
regularly. Check the alignment of all parts, and check the tightness of all  
fasteners.  
Warning: The warnings, cautions, and instructions discussed in this  
instruction manual cannot cover all possible conditions and situations  
that may occur. It must be understood by the operator that common  
sense and caution are factors which cannot be built into this product,  
but must be supplied by the operator.  
Unpacking  
When unpacking, check to make sure the following parts are included.  
1 Back  
1 Front Support  
1 Seat  
14 Wood Screws  
2 Front Legs  
2 Back Supports  
2 Arms  
10 55mm Bolts with nut and washer  
2 65mm Bolts with nut and washer  
1 Owner’s Manual  
If any parts are missing or broken, please call Harbor FreightTools at the number  
on the cover of this manual, or contact your local Harbor Freight retailer.  
SKU 90849  
Page 3  
 
Assembly  
Carefully unpack the parts and check for damaged or missing parts.  
1. Attach Left Front Leg (C1) and Right Front Leg (C2) to Seat (B) using 3 Bolts (H)  
per side. Use the included washers and nuts to tighten.  
2. Attach both Back Supports (D) to the inner sides of the Seat (B) using 2 Bolts  
(H) per side.Tighten using the included washers and nuts.  
3. Attach the Left Arm (E1) and Right Arm (E2) to the Front Legs (C1, C2) using 2  
Wood Screws (G) per side. Attach the Arms (E1, E2) to the Back Supports (D)  
using 1 Long Bolt (I) per side.Tighten the bolts using included washers and nuts.  
4. Attach the Back (A) to Seat (B) and Back Supports (D) using a total of 6 Wood  
Screws (G).  
5. Attach the Front Support (F) to the Front Legs (C1, C2) using 2 Wood Screws (G)  
per side.  
6. Recheck the alignment of all parts, and recheck the tightness of all fasteners.  
7. Set up the chair on a flat, level location. Do not exceed load capacity of 250 lbs.  
Maintenance  
1. This chair is made of natural Fir wood.This beautiful material will naturally  
weather over time, especially if used outdoors.You can manage the speed and  
extent of this weathering by controlling the environment in which the chair is  
used and stored, as well as any coatings you may apply.  
2. Leaving the chair outside exposed to weather, especially direct sun, rain and salt  
air, will speed the weathering process.This can be slowed by removing the chair  
from these conditions, or covering it with a suitable cover.  
3. You may wish to stain, varnish or paint the chair. If so, follow the instructions  
supplied with these coatings.  
4. Occasionally wash the chair with a garden hose or pressure sprayer to remove  
accumulated dust or dirt.Wipe down or blow off any remaining water left on the  
chair after washing.  
5. Periodically (perhaps once per year), recheck the tightness of all fasteners.  
Normal usage of the chair and weathering of the wood may cause fasteners to  
loosen.  
SKU 90849  
Page 4  
 
Assembly Drawing  
SKU 90849  
Page 5  
 
Parts List  
Back  
Seat  
Left Front Leg  
Right Front Leg  
Back Support  
Left Arm  
Right Arm  
Front Support  
Wood Screws  
55mm Bolt  
65mm Bolt  
with Washer and Nut  
with Washer and Nut  
NOTE: Some parts are listed and shown for illustration purposes only and are not  
available individually as replacement parts.  
PLEASE READ THE FOLLOWING CAREFULLY  
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM  
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR  
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE  
BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR  
THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT,  
THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THat ALL REPAIRS  
AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LI-  
CENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK  
AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT  
OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLA-  
TION OF REPLACEMENT PARTS THERETO.  
SKU 90849  
Page 6  
 

Graco Car Seat PD247328A User Manual
Haan Carpet Cleaner SI 75 User Manual
Hans Grohe Indoor Furnishings 10100801 User Manual
Harman Stove Company Stove TLC 2000 User Manual
Hoshizaki Ice Maker IM 122J User Manual
HP Hewlett Packard Computer Monitor 5500 User Manual
HP Hewlett Packard Computer Monitor D8897 HP55 User Manual
HP Hewlett Packard Copier C8431 90109 User Manual
HP Hewlett Packard Network Card Pro100B User Manual
Ice O Matic Ice Maker ICE0400A3 T3 W3 User Manual